Posted by Mike in Mn. on September 17, 2014 at 20:45:09 from (74.46.182.107):
In Reply to: Ferguson sleeves posted by Harry Keller on September 17, 2014 at 15:30:02:
When installing wet sleeves install the o-rings on the sleeves dry, run a pick or similar around the ring and make sure it doesn't have a twist in it and that it lays in the groove nice. Then take a straight edge and lay across the rings and MAKE SURE they are large enough to seal, they have to stick out from the sleeve enough to seal. I have been clipped too many times by all this junk from all corners of the world sold as quality parts. When I buy an Ell-Gippo engine kit I get a set of sleeve seals from the dealer to use, I won't use the ones supplied with the kit. After proper preparation of the sleeve bores I use Ultra Copper sealer as a o-ring lube and a sealer to install the sleeves and have NEVER had one leak since.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoring a John Deere 2010 Diesel Tractor - by Jim Nielsen. Following seven years working in California's Silicon Valley, my wife, baby son and I moved back to Australia to retire. We bought a small 'farm' of about 50 acres near Bendigo, in the state of Victoria. I soon found that it would be very useful to have a tractor around the place for things such as grading our long drive and brush-hogging the fields. I was also embarking on planting 1000 eucalyptus trees, and hence I would need a ripper, small disk plow, sprayer etc. to get these things accompli
... [Read Article]
Latest Ad:
Wanted to buy model 65 massey ferguson 65 diesel
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
