Posted by Jason S. on September 17, 2014 at 18:58:39 from (174.237.39.156):
In Reply to: Ferguson sleeves posted by Harry Keller on September 17, 2014 at 15:30:02:
Harry Keller said: (quoted from post at 23:30:02 09/17/14) After installing new sleeves pistons rings ad valve grind and putting this engine together it leas anti freeze around no 2 sleeveso have to take it all apart,,Did I kink the gasket cracked block or what????Should know when I take it apart..Do I need all new sleeve gaskets .and new head gasker again or???Should these gaskets be coated eith silicone or ? before installing as I thougt they needn't be..Your expert advice appreciated..PS tractor has never even been rolled over with starter..Thanks
To add to this. After you install the sleeves do not turn the motor over even by hand without having the head on or using a big washer with a piece of pipe down over the stud to hold the sleeves in place. The slightest movement without the sleeves clamped in place will move the sleeves and orings and possibly tearing them or rolling them off. The Ferguson shop manual says to lube the orings with Vaseline when installing the sleeves.
This post was edited by Jason S. at 19:01:06 09/17/14.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
