Posted by wisbaker on September 01, 2014 at 08:25:58 from (173.30.33.15):
In Reply to: O.T. electrical posted by plow hand on September 01, 2014 at 07:50:21:
The problem with putting a "reducer" on your welder plug is that big old plug has big old wires and a big old breaker (or fuse) on it. If you plug a dinky little adapter into it your protection (fuse/breaker) is to heavy for the lower amperage device so it could overheat, catch on fire and burn your garage down and your breaker wouldn't do anything to prevent this. To do it safely you'll need to run a separate circuit with the properly sized breaker or fuse for you heater. And how big/small would that be? Need to know about the heater first how many amps does it pull?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Can You Patch a Tire Sidewall? - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "Has anyone attempted (or succesfully) glued or bolted a patch to the tires' sidewall. I cannot afford a tire right now but have some horse stall mat material and could buy some glue. I could use some advice on
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
