Posted by Mogster on August 29, 2014 at 19:21:37 from (172.56.9.211):
In Reply to: Will it hold, welding? posted by Nate V. IA on August 29, 2014 at 17:10:59:
The welds that person did are of poor quality.the heat was too low and you never weld over hot dipped coatings. One weld is only on the bracket and did not penitrate the gate,this is were corrosion sets in and stess cracks form. 24' swing gate has large amounts of stress at two diagonal corners. What can you move with a 24' lever. I have welded 3/8 plate with a 110- flux core. Grind the welds completely off. Improper prep work = bad welds. But who am I to judge. If the man welding was blind then he did a great job for not having a grinder or acid to remove the zinc plating.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Updatin The Charging System of Your Older Tractor - by Tyler Woods. Older tractors have externally regulated generators or externally regulated alternators, in some instances. That means there is one device that turns energy from the fan belt into electrical energy,
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
