NC Wayne: It is just a ratio problem. You need to know the length of the original torque wrench. This is usually measured from the center of the square drive to the middle of the handle you pull on.
So Lets say that is 10 inches.
So using your adaptor the length would be 10+1.5= 11.5
You need to know what percentage the old lever/torque wrench is compared to the "new" length of the combined tool.
So divide 10 by 11.5 = 87%
So the original wrench is 87% as long as the combined wrench.
If you wanted a final torque of 350 foot lbs. you would set the wrench at 87% of that or 304.5 foot lbs.
The only caution is only use the extension/crows foot straight out the end. This makes it a straight level problem. If you go to angles it gets to be a very complicated math problem to figure the actual torque.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: What's The "Stuckest" You've Ever Been? - by Edited by Kim Pratt. Another great discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I was about 14 (part of the problem) when I got stuck. I was disking with a cab equipped IH 966. The window was dirty and I was driving into the evening sun. It was hard to see and it was my first pass down the field. I got the tractor so stuck that the underside of the tractor was resting on the ground. My uncle wanted
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
