The Generator works at POS or NEG Ground and will begin charging at the Polarity to which its Polarized SO BE SURE TO POLARIZE IT BEFORE STARTING THE TRACTOR lest you harm the Voltage Regulator.
To Polarize use a small jumper wire and momentarily flash jump from BAT on the VR over to its GEN/ARM terminal (or down to ARM on Genny) and you should get a small spark.
Some VR"s work at either polarity, others may be labeled for POS or NEG Ground. Many can still work if wrong however the coating on the relays may burn off prematurely. Id advise a VR to match the Genny that"s labeled suitable for your NEG ground although yours may work fine as is, it may work but fail prematurely, I just cant say.
Sounds like you already took care of coil and ammeter.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - On the Road with Dave Gohl: Tractor Club Beginnings - by Dave Gohl. I was surprised about a month ago when I got a call from a fellow tractor croonie. His message was interesting and to the point. He's says "Dave, I've been thinking about starting a Two Cylinder club for our area. What do ya think?" It was a loaded question. I said that I would be interested, and was wondering what his next step was. (Although I was talking under my breath, since I thought of this some years ago) My friend, Arlyn Lamb of Lakeville, Minnesota was sincere in his miss
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
