I can't tell you as the size of a potato, and how many to use, seems to me to be subjective to how hungry you are. That said what I do is boil enough potatoes to feed whomever I am trying to feed.
Basically I dice up the potatoes into about 3/4 inch cubes and then boil them until they are soft. I then drain the water and put in a generous amount of butter, salt, and pepper, and then enough milk to cover the potatoes. I then simmer the mix on a low heat, stirring occasionally until the butter is melted, and the soup is hot.
From there, serve in a bowl, mix in more salt and pepper to taste, and eat with a generous amount of saltine crackers (either eaten separately, or crunched up in the soup to thicken it a bit). Any way you eat it, you can't go wrong because it's that good.......MMMMMMMMMMMMMMMMMMMMMMMMMMM Might have to do that for dinner tonight.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.