Posted by jim in Newberg on August 18, 2014 at 14:15:32 from (50.45.210.158):
[
On this 350 with water in the oil, I have the pistons out and I need to remove the cylinder liners, I tried with a bottle jack and a rod like suggested but they did not move. Does the liner protrude thru the block about an inch or 2? And what is the wall thickness? Thanks a lot. I will be getting a mechanic to look at it soon.
Jim
quote="jim in Newberg"](quoted from post at 11:54:09 08/13/14)
Regarding the 350 with water in the oil, I have the head off and have taken it to the machine shop and they said everything looked good. Took the belly pan off and the oil pan off. It looks like only 2 cap screws hold each piston, wondering if I can take the pistons out thru the top or is there more to it than taking out the 2 cap screws.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A 1937 John Deere Unstuck - by Gary Hickman. Here is my story of how I got the pistons out of a 1937 JD B that the engine had been stuck for about 14 years: About 12 years ago my Dad gave me one of the tractors I ran as I was growing up on our farm in central Nebraska. The engine on this tractor, a 1937 John Deere "B", had been stuck for 2 years before he gave it to me. This last spring (1999) I hauled the tractor to our 2 acre lot in St. Libory Nebraska where it joined my antique machinery collection, at that time a 1929 Caterpillar T
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
