Posted by George Marsh on August 07, 2014 at 12:07:28 from (184.16.227.119):
In Reply to: Woods roads posted by Donald Lehman on August 06, 2014 at 18:49:25:
Don, I have a 3100# T5C terramite. I had a similar problem this spring. The thaw went out of the ground. My road was made using sand and gravel from my old gravel pit. The rock went down and the sand went up. I had a good 2 inches of mud. I used backhoe and pushed the mud to the lowest point in the road. I then went to the local gravel pit and bought the cheap #8 gravel. I would tail gate spread the gravel on the dry place. Then use the loader to push the gravel on top of the mud.
So if I were you, dump your gravel on the dry part of the road, then using a loader build the road up keeping the loader on the new grave as you go so you don't get stuck. Try to relocate some of the mud to fill to the low spots.
If I had really muddy deep ruts, I would get the biggest rock my loader could handle. like try #2 or #0 and work it in the mud. When working in mud with a loader, you will need a ballast weight behind the rear wheels to transfer weight off the front wheels, or you will get stuck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - by Teri Burkholder. The View from the Garage - Never a doubt, everything on our farm is a learning experience. I've been working very hard to get our two rundown Farmall A's sanded, primed , bondo�d, fiberglassed and painted before our big local tractor show called the Tulip Festival. My husband Ben came in the garage one rainy day to see if he could "help". Well if you knew Ben you wouldn't want him anywhere near your spray gun, fiberglass or bondo! So I pulled out the 2 old yucky looking magne
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
