Posted by Mike in Mn. on July 31, 2014 at 07:45:09 from (74.37.51.191):
Posted a while back on tying problem on an old NH super 68 baler. Took the twine fingers off and they had a groove wore in them, the right one worse than the left and that is the side that would mistie. Ground out and polished them up. I had an article I cut out of a farm magazine years ago about tying problems, and it showed my exact problem, string tore off or almost off behind the knot and said was too little clearance between the bill hook and the knife arm, compared it to the good side and I could see the difference, so did some bending on that arm till I was happy with the way it looked. On Tuesday I was baling with the other baler and my Son said should I bring er out and give er a try, I said sure we have a little time to mess with it, she popped out 250 nice tight bales and never missed a one right from the empty chamber and even changed both twine balls. thanks for your comments and encouragement, I was about ready to back it in the woods and pull the pin.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
