Posted by Jared in wi on July 21, 2014 at 18:36:29 from (173.202.142.245):
In Reply to: J D 3020 Fuel Gauge posted by Richard Douthwaite on July 21, 2014 at 17:42:08:
One wire has to go to a power source when the switch is on. Look in that area behind the dash for a power wire, it may be "T'd" with another wire. Are the wires push-on or ring terminals? Doesn't matter, just curious. I did some work on a 1967 4020 a while back so I am just going from memory. It may be "T'd" with the wire going to the cigarette lighter. I have found both in the service manual and in practice the ground for the sender is critical. I have already run a separate ground back from the fuel sender flange to the ground at the gauge. Paul
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
