I started working on Small Engines in about 1975 . I have worked in Good Shops & have worked in Bad ones . When I retired from the Service in 1978 I wanted to open my own shop but the Wife said NO , She said that if someone came in a gave a Sad story that I would just tell them to take the Item .She said she wasn t going to Support the free loaders . Out here in AZ, a lot of the Shops charge $65.00 & up an Hr. I still work on them if someone wants me too , but I always check it over & call with an estimate . I don t change anything that it doesn t need . Save all the old parts for the Customer , Charge about a third of what the Shops charge . I always tell them that I am not trying to get rich but the work I enjoy & relaxes me . I don t work on anything big as I don t have the room . Everyone that I have repaired for people are Pleased with my work & send others to me . Must be doing Something right . John In AZ. [email protected] I have several commercial people ask me what they could to keep their machines out working instead of the Shop , I told them to get an air compressor & keep the trash blown off . they just didn t get it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oliver 550 Clutch Overhaul Tips - by Greg Sheppard. I got my 1964 Oliver Model 550 (serial 141-139-519) second-hand and used it for several years before the clutch began to slip. After taking up the pedal linkage several times I saw it was going to take more than that. The engine had been leaking oil at the rear seal and I suspected
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
