Bret, how? A Mech or Armor division is about 28,000 people. To close a front each Division's front is supposed to be 10 miles. The Mexican border is 1951 miles. Divided by 10 that's 195 divisions. Now you would have to have one BDE in reserve to allow guys time to take leave and such. But you could say stretch it out to 20 miles and cut that in half. Or even 40 miles and make it one quarter. You are still very close to 50 divisions at 28,000 per division. Over 65% are support, cooks, clerks, medics, mechanics and such, people who will not be on the line. We have 10 active divisions now. So you would need the 50 for the southern border plus the 10 for national security and other commitments. Right now with 10 divisions the Army is over 400,000 people. One division is Airborne and they are smaller by about half over the Mech/Armor divisions. So 50 new divisions at 28,000 each would be 1.4 million troops. Then you need barracks and family housing, mess and medical facilities, motor pools and a whole infrastructure. We can't afford it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.