Posted by greglinda on July 16, 2014 at 13:25:15 from (70.88.102.125):
Ok followed the advice on this forum got new lights hooked up. Replace everything. Found good grounds everywhere no problem. Rewired switch as it was. Apparently the ammeter was wire to the light switch. Is this standard? when I run the tractor w/o lights on the ammeter is at zero, when I turn on the lights the needle moves to +10 and stays there until I turn off the lights. !0 amps is about right for the lights I installed headlights have a in line fuse rated 15 amps and tail lights have a inline fuse 15 amps as well. Question: am I doing any harm to the tractor, ammeter, battery or generator by running it this way? On advise from the forum I did not wire to the keyed starting switch so I have to remember to shut the lights off. Everything seems to be fine just wondering if I did this wrong?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
