Posted by gwece on July 16, 2014 at 06:24:45 from (184.11.102.178):
In Reply to: Moles posted by rohdog50 on July 16, 2014 at 04:42:16:
I share your pain on the moles. From what I have read on moles they normally don't eat plant roots. They may disturb the root system as they tunnel. The main diet of moles is earthworms. Voles, however will eat plant roots and will use the mole tunnels. The experts say that most mole repellant methods do not work (see the link below). What works the best for me is a 20 gauge shotgun. I have discovered something just this week that has helped me a bunch. Keep in mind that my soil is not sandy. What I discovered is that if you take a shovel and dig up a 12 inch section of the main mole run and clean the exposed ends of the run, the mole will fairly quickly try to seal the exposed ends of of the run with soil. Just wait to you see the soil coming and fire away. They say the mole can sense the airflow. This will also work for the moles that make the big "volcano" piles of dirt and don't have visible surface runs. Just take a shovel, remove the volcano and dig a hole about a foot wide and down abut 8 inches. This will expose the horizontal tunnels normally going two directions. Again clean the holes and leave open. I had a mole this week that tried to seal the hole within 5 minutes of when I opened it up. Granted you have to have a little time on your hands, but this method has been effective for me.....think I have killed 5 or 6 this week alone.
You might take a look at utube for the cinch trap videos. I ordered a couple of these and set them one time, but the mole just tunneled down and around the trap. I probably didn't have it set properly in the tunnel. I am going to try again if I don't have time to "shotgun" hunt! Good Luck
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Price Enthusiasm? - by Anthony West. Quite frankly, for some time now restorers like myself have become more and more concerned about the rapid increase in the prices of old farm machines here in England. There is now a growing market for "As found" machines. Which as machines get rarer, has found the birth of a new industry....one of the "procurement agent". These agents appropriate as much old machinery as possible then inflate prices at auctions. So at what price enthiusiasm? We are now seeing poor machines which 3 years ago ma
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
