Re: g2000 kubota bellymower lawntractor 54 inch
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk ]
Posted by J. Moore on July 30, 1998 at 17:29:22:
In Reply to: g2000 kubota bellymower lawntractor 54 inch posted by l. worthington on July 19, 1998 at 16:28:40:
: My bellymower will not cut the grass smoothly on the discharge side. It just started this about 3 weeks ago and leaves a streak of grass that looks bad. the bearings are tight, blades not bent, air pressure in tires even. Could it be belt, it seem tight but does have some play in it. Any help is appreciated. If you have checked all the other, it is most likely in the linkage that attaches to the mower deck. If the front turnbuckles are not the same, it will raise one side of the deck. Also, the linkage in the center is adjustable and may have vibrated out a few turns. Suggest you pull onto a level area, measure from the edge of a blade down to the ground (cement) and adjust so they are both the same. Double check that your wheel pins are in the same holes. Check the decal to be sure of which holes they should be in. Don't assume they are suppose to be in the same ones. The right side may be different from the left one.
Follow Ups:
Post a Followup
|
