Posted by Buzzman72 on June 20, 2014 at 07:45:02 from (74.138.169.48):
Let me preface this by saying that I have very little knowledge of geothermal heating/cooling systems. I'm not a "lieburral" tree-hugger by any means; I'm just trying to come up with an idea that may help Mom on her heating/cooling expenses at the farm. [And she has a Farmall Cub, in case anyone would object that there's no tractor-related content in this post.]
The house is heated by an oil furnace. As you all know by now, oil prices aren't going down...and since her last heating oil purchase was invoiced as "#1 off-road diesel," it probably won't get any cheaper this off-season, with all the political stuff going on.
The farm house has TWO old cisterns located near the house. One was used as recently as 20 years ago, when grandma finally decided to go to 100% "city water." Mom says the other cistern leaks; my uncle, who also has an ownership interest in the farm, says BOTH cisterns leak.
Leaks aside, I'm wondering if we might just dig up the tops of those two cisterns, and install a couple of those modern poly cistern tanks as a "liner"...and then use the cisterns as a geothermal source.
Would it work? Why or why not? I'm thinking that using the 53-54 degree F water in these existing cisterns [re-lined] would make more sense than digging up the yard or the barn lot to run a lot of lines...IF it would work.
So...does anyone who is experienced in dealing with geothermal heating and cooling systems have an idea? I know you could give me a more accurate answer if I knew how many gallons the cisterns are, but I simply don't know.
There is no natural gas line nearby...so the only options are the existing oil furnace, propane [I have propane, and I do NOT recommend switching to it], or wood...which she would have to purchase...and at 82 years young, I don't think she needs the added work of feeding a wood furnace. I just think that a geothermal heat pump "assist" might make her oil usage go down, and cut her heating expense over the long term...as well as enhancing the value of the property, should they ever decide to sell.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
