Posted by Stick welding on June 15, 2014 at 20:26:21 from (96.53.210.246):
In Reply to: Ouch!!!! posted by Notjustair on June 14, 2014 at 20:39:33:
Always best to go to a Dr. or the emergency to see if something got in your eye. Guys that don't wear at least a shade 3 lens when using a cutting torch CAN damage their eyes over time. My dad knew a guy that went blind and all he ever did was oxy/acet welding and cutting without the proper lens. They don't do eye transplants!
The effects of a flash usually happen hours later and it feels like someone is sandblasting your eyes. Effects usually go away the next day. If it's a bad flash, the Dr. will put drops/cream in your eye and an eye patch for a couple of days. Luckily I've never had one that bad. I have had rust and metal filings in my eye before so like I said, it's always a good idea to get your eyes checked. Most times I got flashed, I remember seeing the big white spot when I went to strike an arc again. Had to wait a bit till I could see properly.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil�s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
