Posted by Ultradog MN on June 14, 2014 at 04:50:22 from (174.20.238.34):
In Reply to: Ford 600s posted by JerryS on June 14, 2014 at 02:45:04:
Workmaster is a 601 - same tractor as a 600 only a bit newer. I don't mess with the 4 cylinder Fords so much but think that some governor parts are NLA. Other Ford men here will correct me on that. Prices are a bit high I'd say. For the one with the cracked/fixed block which though it may run well is still a serious flaw. And new tires are a Grand for the other one. Leakdown on the lift is a $25 piston seal and gasket from this site so no big deal. I don't buy from resellers as they need to make a living too and their prices will show that. Have you tried searchtempest dot com? Plug in your zip code and how far you want to travel and see what's on craigslist in many cities.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
