in-too-deep, When I was farming the Okla. Panhandle, Some neighbors of mine a few yrs would use a regular ol grain drill to plant Double row milo On the Top of a row. (roughly the 11:00 & 1:00 position on a row top, the 12:00 can be used too for 3 row!) In a row water situation. Guys would take the tension off the individual disk openers so not to plant too deep. ((Block or tape off the units you were not using))! A 12 ft drill is perfect if you are on 40 or 38 in rows. one doesn't need to lift up or remove any row units. Just take all tension off the row units and they will not plant too deep. Nothing special, Nothing fancy just eye up which openers need to be open and those they need to closed, and remove all tension from all openers! Hope this helps! Adjust your seed rate to match your Plant Population! Hope this helps! Later, John A.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Super Dexta - by Anthony West. The rusty blue tractor caught my eye as my truck zipped by the farm implement business. It looked so fornlorn amongst the lineup of newer equipment. But it was just the right size for my small farm. I stopped in and asked the proprietor for further information. "It's a 64 Ford Super Dexta", he said. "It's a tough little tractor, although it's a hard starter being a diesel and all." He did manage to get it running, compliments of a can of ether. Once started it putted along pretty good. It
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
