Posted by Kerry50 on May 29, 2014 at 21:44:43 from (72.161.159.15):
My buddy Mark and I went to Springfield, MO today to see the ATHS truck show. Had an awesome day there visiting with these guys and admiring their work.
I am an admirer of the B Model Mack. Would love to have one to haul my tractors with to local shows and parades.
Recognize what this contraption is?
When this one fired up, it sounded more like a Duramax than a Mack, lol.
We we're really impressed with this 8020 John Deere and his GMC road tractor, "Lets Roll".
I had never seen a pto pump hooked to the cylinders on a dump truck before.
Lots of Diamond T pick ups there. Mark was watching me instead of the lady about to exit this one,,,,,,,,LOL
This Diamond T in its "work clothes" was one that I thot Sweetfeet would appreciate. Check out the fan on the steering column.
Hand crank dump mechanism for a dump truck. It has Little Giant stamped on it, my grandad had a Little Giant grain auger at one time. Think this could be the same company?
Last but not least, we caught this p/u on our way out.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
