Posted by farmallhal on May 27, 2014 at 17:20:05 from (76.2.172.190):
In Reply to: Re: Disc mower posted by Nathaniel Watts on May 27, 2014 at 16:53:23:
That could be part of the problem as the only place wide enough to store it undercover slopes left to right about 10 degrees or so and is level front to back. Maybe I need to build an open bay building wide and high enough to get the tractor and mower in with the mower cutting bar parallel to the floor. We certainly try and block it so as to be in correct relationship to the tractor when un-mounting it but something always gets out of place and the jacks, levers and any other moving or lifting devices come into play to muscle the heavy thing into submission. I'm afraid someone is going to get hurt one of these days and there has to be a better solution. I have three IH Farmall tractors with their 2 point fast hitches and hooking up to large, heavy and awkward implements is so easy but disc mowers came along after the shift toward the big 3 point implements. I think a building with a level concrete floor with an unobstructed opening of around 20 feet wide and probably 10 feet or so tall might be a good start to easier hook ups for the disc mower. Thanks for your response, Hal.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Wanted to buy model 65 massey ferguson 65 diesel
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
