Posted by DeltaRed on May 24, 2014 at 21:22:01 from (65.100.146.82):
I've come to the conclusion that I need to update my corn planter.It's a 1960 +/- JD #70 unit(6row)'.Been a good planter,but starting to have some issues.I'm done for the year,so a newer one is not an 'emergency'.Been thinking that maybe a pull behind might be the way to go.Thinking a JD 7000(4 OR 6 row is fine).Notill is not an issue.But I need/want disk openers.And I want to continue to use the SuperM to plant with.I am going back to 'pre-marking'(bedding),so the planter will(or should) follow the marks/furrows.Any suggestions?I was also thinking that an 'older' (small) planter may not be to expencive.There are no pulltypes here(everything is 3point),so it would have to come from 'back east'/midwest here is a pic of the 'old' one. Thanks,Steve
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
