Posted by Eldon (WA) on May 23, 2014 at 19:31:13 from (98.225.11.231):
In Reply to: MX10 mower posted by David G on May 23, 2014 at 18:48:08:
Quoting Removed, click Modern View to see
I ran an MX8 for 3 years in my custom tractor work business. It did a poor job of cutting in tall grass, left the center high. I bought a new Bushhog 3008 and the cut is near perfect. It has baffles under the deck and a blade design that makes the difference. The JD used a bolt to hold the stump jumpers on, I had one that always wanted to come loose and would fall off at the worst time. BH uses a castellated nut and cotter key...much better. BH is also a little shorter, front end of tractor is not in the air as much. Good thing about the JD, I sold it for what I paid for it after putting about 800 hours on it....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1929 McCormick-Deering 10-20 - by Randal Simmon. On July 4th 1998 my dad and I was sitting on the front porch when he said that he was going to sell his two 10-20's to a junk man. He said that the junk man was going to give him $500 for both of them but he hadn't received the money for them yet. So I went into the house and wrote him a check for $500 and bought them myself and said now they are mine. He had bought them about five years before thinking that he was going to restore them himself. After five years sitting in the barn, he changed h
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
