Part of it with both the St B and Irish is where they come from. You get a St B from parents the you can see, that you can watch interact with people that acts liek you want and you have a lot better chance of not getting an aggressive dog. Get one from a pet store or puppy mill, all bets are off. Same for the Irish, get a pet store/puppy mill dog and you'll likely have a brain dead moron that bites. Find a field bred Red Setter (I think that's what they call the field bred Irish Setters) and you may well have an old style Irish like from the 40's. Go to a reputable breeder or people you know if you want a decent dog.
As far a farm dog, no I don't think a St B is a great choice. Pyrenees have been mentioned. We have 3. Smart, loveable dogs that don't eat all that much. 2 of our live with the sheep 24/7/365. The problem is if a fence goes down. Within 4 hours we'll be getting calls that our dogs showed up 5 miles away or they show up 24 hours later at the barn after covering a huge area crisscrossed with roads. I worry greatly they'll get hit and I really dislike my dogs not being where I want them. They wander and they aren't great on coming when called. I hate people who inflict their dogs on other people. So if you're fenced, they make a good dog. Ours are not aggressive towards people, but you don't want to be anything that might be a coyote!
A better choice might be an old style Lab, Shepherd or Collie if you can find one. Something with a bit of territorial instinct, a moderate barker at the unusual and something that likes being around the house/barn. But there is no certainty in any breed.
This post was edited by Bret4207 at 04:28:48 05/23/14.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
