Posted by CAS on May 22, 2014 at 07:57:58 from (67.240.133.144):
In Reply to: 1755 PTO Gasket posted by UP Oliver on May 22, 2014 at 06:17:55:
I'm negative on silicone too. Have fournd too many pieces loose in the wrong places over the years. For the old gasket, I pull off as much as I can(do not spend much time on it). Then I take a 4&1/2 inch angle grinder and put a twisted steel wire cup(3 inch). Just run it slowly around the housing and it will quickly tear off the gasket. No scraping or other aggravations. You will have a nice clean surface. Then, I like to use permatex #2 gasket sealer in a tube(about$3.00) Just tab it around several places on the gasket. Press on the housing a couple times and your all set. Should take about 10 to 15 minutes.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A 1937 John Deere Unstuck - by Gary Hickman. Here is my story of how I got the pistons out of a 1937 JD B that the engine had been stuck for about 14 years: About 12 years ago my Dad gave me one of the tractors I ran as I was growing up on our farm in central Nebraska. The engine on this tractor, a 1937 John Deere "B", had been stuck for 2 years before he gave it to me. This last spring (1999) I hauled the tractor to our 2 acre lot in St. Libory Nebraska where it joined my antique machinery collection, at that time a 1929 Caterpillar T
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
