Posted by rrlund on May 17, 2014 at 15:36:10 from (162.250.26.144):
In Reply to: Snap Rings posted by UP Oliver on May 17, 2014 at 12:37:54:
Why not just soak it in gas then blow the crud out with compressed air?
If you're bent on getting it out,I think I've had one out once,and that was by mistake the first time I took one apart. You'll need three screwdrivers just the right size and somebody to help you. Get two of them straight down in to it. One against one end of the ring,the other has to go against it so that they form a V with that one against the other end of the ring. Now twist so that one of them pushes one end of the ring out. Now have somebody else stick a thin one in the little bit of gap. Before it slips out,get an o-ring pick in there and turn it so the hook sticks out toward the center of the gear to keep it from slipping back in. Work a screwdriver around it now and work it up and out. It's more trouble than it's worth.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Oliver 70 Row Crop - by Staff. The Oliver 70 was part of the "Fleetline Series" and was manufacturered from 1937 to 1948. The row-crop configuration could have either dual or single front wheels. The Oliver 70 was also offered in the standard, orchard and industrial configurations. The tractors were sold in Canada. An early advertisement states "Power when you want it - power when you need it - power to help put in crops when field conditions are right and time and help are limited. That's the power you'll find in an Oliv
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
