Posted by Indiana Ken on May 11, 2014 at 18:24:48 from (66.249.228.77):
In Reply to: Stump removal posted by Joshua Rod on May 11, 2014 at 08:55:08:
I have tried Gordon's Stump Remover on two stumps, neither one decayed or burned as promised on the bottle. The big problem I have is drilling a 1" diameter hole 10" deep into the stump, then intersecting it with another 1" diameter drill from the side. Really now, it takes a better drill than I have to drill that kind of hole in a green stump and a better man than I am to hold on to that drill.
I usually cut them low and treat them with a stump treatment. They will not begin to decay until they stop sending up sprouts - I find the stump treatment is key. If it is a pasture or fence row I only need to get a bush hog over them every now and then. If you need to farm over them then waiting several years for rotting is not acceptable.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather�s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
