Posted by Robert in Md. on May 08, 2014 at 18:15:52 from (97.73.48.124):
Built pole shed last August concrete floor poured Sept . Decided to seal floor this week. Purchased L & M Dress and Seal WB and applied it Tuesday according to directions , dryed and looked fine. Applied second coat Wednesday , it dryed and looked fine, Looked at floor this morning and it had dryed conpletely and I was satificated. Purchased another 5 gallon can this afternoon to do the other half of the shop. Went in the shop about 4:00 Pm and the floor was wet and malky with about 1/4 inch of water on it.
What happened. the tem yestesday was about 65 degrees and today it rose to about 80 degrees. At 4:oopm the floor was wet and malky and looked terrible.
I called the fractory rep and he didn,t have any ideas.
He really implyed that I had a leak , the shop doen,t have any water access.
I do not want to finish the rest of the floor if it is going to look like this.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for �200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
