Posted by tomturkey on April 29, 2014 at 11:21:41 from (216.81.211.253):
In Reply to: Concrete questions posted by JohnDeereJimOhio on April 29, 2014 at 09:32:57:
Concrete does not dry, it is called the hydration process, a chemical reaction between the water and cement. If the construction industry only placed concrete in the spring and fall, we in the midwest would never get concrete work completed. Spring the subgrade is wet and unstable, fall, days are shorter and low temps increase the cure time and potential for freezing. Concrete will crack at any temps, summer temps will increase this probability. So the use of control joints at 8 to 10 foot intervals will "cause a weak spot where the contracting or expanding concrete can relieve pressure and crack along your control joint cut. Cut must come within 24 hours of placing or as soon as cut can be made with out damaging the surface of the concrete and be approximately 1/3 the slab thickness. If this is a diy, do it in small bites, better to wait on the cure so your finish is what you desire, not fighting a flash set that you cannot catch up with. Do not add water to the surface to get a more workable concrete cream, it weakens the top 1/4 inch and will spall and durability and weather resistance will be compromised. orry for the long post, spent most of my working days around concrete. Buildings, bridges, roadways. Placed concrete in every month of the year. Just have to know what must be done to have the end result be a good product. I wish you well gobble
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
