Posted by Frank 41 on April 15, 2014 at 17:49:33 from (50.122.43.2):
In Reply to: Grain Bin pad posted by LeonardWD45 on April 15, 2014 at 08:09:28:
We did like Vic said with the pipe for the center that also worked for smoothing down the crete when you poured it. If you had a small trencher, chain it to the stake to cut your footing. Drill a verticle hole in the 2X4 and put a long bolt in it that will fit the ID of your pipe to smoothit down. We used light plywood that would bend easily and we put oil on the forms so the crete would not stick. There are lots of ways of making a sump if you do not use an airation floor. Put in at least a 8" tube. You could scoop faster than a 6" would unload it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Old Abe is Still Making Hay - by Jeremy Sweeten. Things have changed a bit since my last article. I am now almost finished graduate school at Purdue University. I am still in Agronomy, but specializing in hay and forages. My wife has survived two years of marriage to a part-time farmer. The equipment line up has changed a bit too. The DC has retired to
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
