I was to an Allis Chalmers collector estate sale yesterday at Concordia,KS and prices were strong on lots of the tractors and combines..
UC Allis unrestored $4100-not running G Allis unrestored-bad tires -not running $3300 WD-45 Allis unrestored $2600-nice with good tires WC Allis with wide front -poor paint job $3000 -ran nice RC Allis $1500--ran nice Early WC $1500 - ran nice CA Allis restored $2500
The best buy on the sale was a nice early WC Allis on rear steel for $400..
The combines all sold good.
1951 R Gleaner $3000-nice SP 100 Allis $2750-not running T Gleaner SP combine #1001 1st built $1250-not running (3) 40 AC's $850,$600,and $600 Rough Gleaner combine on a Fordson $4200
The small stuff sold great..
AC one way $1250 AC 2 bottom plow on steel $375 AC silage chopper $900 Bell City 1 row corn picker $2400-unrestored-yes $2400 AC space heater $600 AC power washer $150 AC chain saw $275 AC garden tiller $275 AC push mower $80 B-1 Allis garden tractor $500 unrestored
See the combine forum for more pictures..I have posted a link to the sale bill that has pictures.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
