Posted by Rick Kr on April 13, 2014 at 10:34:53 from (198.105.227.103):
In Reply to: What size pulleys? posted by Dan T in MO on April 12, 2014 at 21:57:02:
Dan, I just measured my pulleys. 2" on the motor, 14" on the mixer. 7:1 ratio. So if you have a 1650 rpm motor, it should be around 235 rpm on the top shaft, then the cog will slow it down from there.
Don"t forget if you are going to mix off the PTO you likely will be running at idle, so that will change your calculations quite a bit, versus 540 RPM where your tractor is around 1700-2000 rpm. You may be closer to 1:1 at idle, versus 2.3:1 (540/235)
This is on an old post WWII Sears & Roebuck that I inherited from the wifes grandpa.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Old Abe is Still Making Hay - by Jeremy Sweeten. Things have changed a bit since my last article. I am now almost finished graduate school at Purdue University. I am still in Agronomy, but specializing in hay and forages. My wife has survived two years of marriage to a part-time farmer. The equipment line up has changed a bit too. The DC has retired to
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
