Posted by vernon in ks on March 27, 2014 at 06:25:47 from (66.210.29.131):
In Reply to: cost of fence posted by farmerwithmutt on March 26, 2014 at 15:04:08:
Putting in a half mile fence now. I'm not using woven wire (hog fence). Doing 5 wire barbed. Going rate for fencining here is $25.40 a rod(16.5') for materials and labor but does not include corners and brace. I'm using 6" pipe corners and braces set 5' deep with concrete and (2)2" pipe cross ties. 6" pipe is $10 a foot and 2" pipe is $2 a foot. Tractor supply has 5.5ft T posts for $3.59 and Red Brand 12.5 guage 2point for $60 a role. My fence is L shaped. Material cost for me 7 x 9ft corners = 63ftx$10=$630.00 8 x 8ft 2" pipe = 64ftx$2=$128.00 220 T post = 220x$3.59=$789.80 10 roles wire = 10x$60=$600.00 28 bags quikrete = 28x$3.75=$105 Total $2252.80 Can it be done cheaper? You bet but this is a 50 year fence.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Step by Step Carburetor Overhaul - 1952 Ford 8N - by Don Stewart. The carburetor kit for the TSX-241A/B/C carburetor is being supplied in only one flavor nowadays. It includes a replacement throttle shaft, new butterfly valve screws, fuel inlet filter, new float needle and seat, new float pin and
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
