NO, don't weld them!!! Like was suggested and used by many, make some channel iron extensions to fit over the existing forks. Take some channel that fits over the fork, weld a few plates about 4" long on the bottom to box it in and drill holes to put a pin across the back behind the bend in the existing forks. You only need to add 12". Probably lots of pictures of fork extensions on the net. OSHA really frowns on modifying forks in any way, including just putting a small hole in the fork for a pin to pull things backwards. DON'T ATTEMPT TO WELD FORKS TOGETHER! Forks are certified and modifying them voids the certification. I realize you just want them for your own use but DON'T attempt to weld them. Depending on the particular fork, they might be weldable but even then it would have to be done in a controlled environment done by a qualified welder using a very specific welding procedure. Along the same lines as never weld on steering or suspension components on a vehicle. Anybody telling you otherwise doesn't know what they're talking about. 7018 would NOT be the proper rod for welding forks even if they were weldable.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
