Posted by IrvIa on March 16, 2014 at 19:43:58 from (207.199.229.145):
Here's sandblast cabinet I built a couple weeks ago. I made every piece out of scrap plywood and OSB board I had. I lined it with tin to keep from have splinters in the sand. I made it 42" x 42" x 60", big enough so I could put a whole Ferguson hood in it. I found the grate in the metal recycling yard AFTER I had it built. I fit just about perfect. Beginners luck! I'm using a barrel vac for the dust, but it's not sufficient after running the sand through a few times. I'm going to look for a dust collector and run it straight outdoors. I have to expand my inlet opening also...not enough area. Works pretty good for having less than $100 in it. I already had the blaster, got it at a swap meet a few years ago for $40.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A 1937 John Deere Unstuck - by Gary Hickman. Here is my story of how I got the pistons out of a 1937 JD B that the engine had been stuck for about 14 years: About 12 years ago my Dad gave me one of the tractors I ran as I was growing up on our farm in central Nebraska. The engine on this tractor, a 1937 John Deere "B", had been stuck for 2 years before he gave it to me. This last spring (1999) I hauled the tractor to our 2 acre lot in St. Libory Nebraska where it joined my antique machinery collection, at that time a 1929 Caterpillar T
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
