Posted by LOU from Wi. on March 14, 2014 at 10:31:36 from (174.124.59.26):
Good Morning Jd, I know that you will have the answer for me,and may possibly impose on you for a picture. Our OC 46 track adjuster will in time need lengthened to take the slack out of the track. I was hoping you would have a picture of the wrench used for that purpose, preferably an Oliver designed for this purpose. What we used is an old Ford wrench, it works, but not like it should. Sometimes it's too close to the ears on the nut. If I had a picture with measurements, we could make one, that would absolutely fit.I am only asking for this information,IF YOU HAVE THE TIME. We are going to have to order another lock nut for the adjuster nut,cause there is only 1 on one side. Thank you in advance, Respectfully, LOU
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.