Posted by Chris(WA) on March 14, 2014 at 08:04:21 from (75.165.9.46):
In Reply to: Large crackers posted by krm on March 14, 2014 at 07:34:19:
A surprising number of people have asked your same question. It looks like that after a quick search , they are no longer around but...You can always make your own! Homemade Saltines
(Adapted from Gourmet, 2007)
Olive oil for brushing pan and dough 1 3/4 cups unbleached all-purpose flour 1 1/2 teaspoons baking powder 6 tablespoons cold butter, cut into bits 1/2 to 2/3 cup very cold water 1 teaspoon flaky sea salt, such as Maldon, or kosher salt Preheat oven to 375�F with racks in upper and lower thirds. Brush 2 large baking sheets generously with oil.
Toast 1 teaspoon coarsely ground black pepper in a dry small skillet (not nonstick) over medium heat, shaking skillet occasionally, until fragrant, about 1 minute. Cool pepper.
Whisk together flour, baking powder, and 1/2 teaspoon table salt in a bowl (or pulse in a food processor). Add shortening and blend into flour mixture with a pastry blender or your fingertips (or pulse in processor) until most of mixture resembles coarse meal with some roughly pea-size lumps. Drizzle evenly with 1/2 cup ice water and gently stir with a fork (or pulse) until incorporated.
Squeeze a small handful: If it doesn�t hold together, add more ice water, 1 tablespoon at a time, stirring (or pulsing) until incorporated, then test again.
Divide dough into 2 portions and flatten each into a 3-inch square.
Roll out each square on a lightly floured surface with a lightly floured rolling pin into a 20- by 8-inch rectangle. Trim edges and sprinkle each sheet with teaspoon toasted pepper. Run rolling pin lightly over dough to embed pepper in pastry. Brush each sheet with 1 tablespoon olive oil and sprinkle each with 1/2 teaspoon sea salt.
Cut sheets crosswise with a small sharp knife into 1-inch-wide strips (straight or wavy). Arrange strips evenly spaced in 1 layer on baking sheets and bake, switching position of sheets halfway through baking, until golden, 16 to 20 minutes total. Transfer to racks to cool.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.