Posted by VaTom on March 05, 2014 at 15:24:02 from (70.32.203.33):
In Reply to: Solar heating? posted by 55 50 Ron on March 05, 2014 at 09:58:58:
Ron if you are building new, you can build a shop that will never get cold or hot. I have one. The system is called Passive Annual Heat Storage (PAHS). Not my invention, I read the book 30 years ago and decided it was what I needed.
The basic idea is to dump excess summer heat into the building mass for later retrieval as winter heating. Not a few days' heat storage, but six months'.
If you are looking for retrofit heating, PAHS is not it. You will do well with active solar panels, as described here. Lots of variations on that theme. BuildItSolar.com is a large website dedicated to the subject.
PAHS can provide an annual indoor temperature that hovers near 70� F. A little colder in winter, a little warmer in summer. This is independent of latitude. Works in Alaska, works in Texas, with some minor adjustments to the design.
We have had our coldest and snowiest winter ever here, snow on the ground for the past month. Interior temperature has never dropped to 63� F, with no supplemental heating. We are often not home, no problem as this is a totally passive system.
This is not particularly good performance because when I built I didn't understand how PAHS works. Better designs will maintain 68� in January.
Houses are the primary interest of course, but the same principle applies to any use. Cost of construction is favorable compared to stick built, usually cheaper.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Machine Shops - by Curtis Von Fange. It is a story that repeats itself countless times. In the process of rebuilding a particular section of the tractor there is a broken part for which a replacement cannot be found. The parts houses find in their catalogue that it is unavailable. The dealerships call it a discontinued part. Salvage yards define it as hard to find or, even worse, rare. Everyone on the NET says, 'what is it?' But don�t despair there is another avenue that can be used to get that piece repaired. The local mach
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
