Posted by gtractorfan on March 05, 2014 at 14:49:32 from (71.66.229.3):
In Reply to: feature night? posted by Larry@stinescorner on March 05, 2014 at 14:28:32:
While working in a job shop I tack welded nuts to the jaws of a couple vice grips at an angle, then cut the nuts in two. This was handy for using with threaded rod and T nuts in mill or drill press tables with slots. It allows quick locating the nut to the toe clamps, then close the vice grip, give it a twist and the hold-downs are tight.
Yesterday you had a thread about protecting mailboxes, I had some smashed until I used expanded mesh on a post next to the mailbox. I leave this up year round and haven't had any trouble since. Also have a spring pop-up flag for when the mailman opens the lid to show the mail's there.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Pop's Tractor of Gold - by Gary Teate. My father was a simple man but could repair just about anythin mechanical that was ever made. From the time I was a young boy growing up in Jacksonville, Florida, I would spend a considerable amount of time helping my father repair or rebuild equipment and engines, etc. on our 2 1/2 acre "spread". Pop always dreamed of having more acreage out in the country where he could retire and tinker as much as he wanted and often reminisced about his boyhood days on his grandfathers farm in Montecello,
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
