Posted by jimg.allentown on March 05, 2014 at 04:35:32 from (98.115.105.174):
In Reply to: Fie wood.... posted by Jared in Wi on March 04, 2014 at 20:05:55:
Here is a bit of a shortcut to getting a reasonable idea of the actual cost.....
First a few "constants." 1) Assume a cord of wood = 100 gallons of oil. To be fair, I will say that the 100 gallons would equal a FULL cord and not a FACE cord. Most wood around my area is sold for about $175 for a full cord.
2) Home heating oil runs right around $3.50 per gallon.
3) 100 gallons of oil @ $3.50=$350.00
4) Assume that the guy that sold you the cord of wood actually made a small profit selling it yo you. After all, he IS doing it for a profit isn't he??
So far, it looks to me that using wood as a fuel costs about half as much as oil. Now, if you own the land and the equipment already, this defrays some of the costs. After all, if you own the land, you do not have to purchase the wood. And, if you own the land, and are farming it, the necessity will arise where you have to remove fallen/dead/rotted trees whether you burn them or not for heat.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.