Posted by greg k on March 02, 2014 at 07:29:10 from (70.197.212.165):
In Reply to: Re: grrrrr posted by John_PA on March 02, 2014 at 06:45:40:
OK, the 1/0 was figuring for voltage drop on a 100 amp panel. If you want to go to 200 amps that is a minimum of 4/0 aluminum or 3/0 copper. With 200 amps I wouldn't worry about voltage drop since you will probably never come close to using all of that power. Yes I would use direct bury rated aluminum cable. I also would put it in PVC conduit to protect it but that step is not necessary. If you use large radius 90� bends it will pull in easier, I believe they are 36" radius bends. Panels in the sheds that feed off of the first shed are considered sub panels and need to have the grounds and neutrals kept separate and need a separate ground and neutral wire run to them. Assuming there is room under the meter you could try putting a large PVC junction box under the meter and, using gutter taps, splice off to the house and shed while leaving the meter in place. You can usually buy wire cut to length at a wholesale house or big box store. Also make sure to check local rules and regulations since they can vary widely from one place to another. Your best bet may be to check with a local electrician and see if he is willing to work with you on some of this stuff. If you still want to come out of the house panel then I would not figure on using more than a 100 amp panel since it will be very difficult to feed 4/0 out of a regular panel. If someone else has ideas I hope they will join in.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want � unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Wanted to buy model 65 massey ferguson 65 diesel
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
