Posted by Bryce Frazier on March 01, 2014 at 11:06:56 from (67.142.182.22):
Hi all. Well yeserday morning I stumbled across a couple of FH implements. Two bottom plow and a disc. Me and a buddy went to look at them, and I took some measurements of the prongs, I would like to know if they will fit my Super C WITHOUT modification, and if not, what it would take to make them fit. The price is right, $300 for both. The disc has had some repairs made to it, and the plow is missing both coulters and one bracket. Here is a picture of a prong I found online. I stuck it in Paint to point out what my measurements are for.
A: Sorry, I forgot where A should go, it is in the WRONG spot, I measured the actual notch, not the rise leading up to the notch. The notch is 2 inches tall.
B: B is kind of in the right spot. It was obvious when looking at them, that after the notch, it continued to rise a little bit, then leveled out and stayed the same all the way back to the implement. When it QUIT rising, the prong was 2 1/2 inches thick.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
