Posted by Steve@Advance on February 28, 2014 at 20:58:01 from (107.203.134.67):
In Reply to: OT- Oil Pressure posted by steamnjn23 on February 28, 2014 at 20:41:17:
The bearings don't make oil pressure, they retain oil pressure.
The oil pump delivers a given amount of oil per revolution. The faster it turns, the more it pumps.
When the bearings wear, or the pump wears, (really a combination of both), there is not enough volume of oil being pumped at idle to fully pressurize the system. The oil takes the path of least resistance, so any excessively worn component dumps the oil back to the pan instead of sending it everywhere it needs to go.
Are you sure the problem is really low oil pressure, not a defective gauge? Might check it with a known good mechanical gauge.
In rare cases the problem can be a defective oil pump, stuck open relief valve, or fuel contaminated oil.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fabricating Sidesheets - by Chris Pratt. The easiest and best first-time project for wanna-be sheet-metal workers like myself is flat or nearly flat metal cut and drilled to be a tractor's sidesheet. A sidesheet is sheetmetal to cover either the engine as in the case of early Oliver's, Massey-Harris' and many crawlers or the wiring and electrical components as in the case of the Massey-Harris Pony, Allis Chalmers' D Series (D-14, D-15, D-12, D-10, D-17, and D-19). The need for fabricating becomes obvious when you go to buy any of these
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
