Posted by Zachary Hoyt on February 28, 2014 at 18:54:44 from (173.84.190.99):
In Reply to: Re: woodchuck sawmill posted by steve terplak on February 28, 2014 at 17:16:46:
I started out with a 10 HP and last fall when it was getting tired I bought a 13 HP harbor freight engine to try out on it. It is just a matter of how fast you want to cut. I have maxed out the size on the 30" mill a few times but we have few trees here on the premises that are that big or bigger. The issue is not so much that the log overall is too big but most logs are not perfectly straight and you have to find a way to get the legs of the mill head past both sides at the same time all the way down the log. I would ask to run it before you commit to the deal and see what you think. It looks like it would be very easy for material to build up on the rails where the head rolls and anything there will throw your alignment and straightness of cut out of whack. Some of the pictures on the website show what looks like buildup of sawdust there. The Turner has pulley wheels that run on a 1/4" wide track and the C channel frame covers the tops of the wheels so that sawdust doesn't fall from the head directly on the wheels or the track. The other thing I would look at is the steel of the main beams. The Turner I have has 3x4x1/4" (if I remember right) angle iron for the lengthwise frame of the bed, if the 2x4 tubing is thinner I would be nervous of it. It is surprising how much hard a log lands on the mill when you turn it or roll it on and it can really do a number on lightly built frames from what I have read. You could also ask on forestryforum or woodweb sawing and drying forum to see if anyone has had personal experience with your mill. Zach
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Torque Wrenches - by Curtis Von Fange. When working with fasteners a torque wrench can play an important role in the correct assembly of critical equipment components. Lets examine in detail some of the reasons for using a torque wrench along with how to correctly use the variety of wrenches available. Applying the proper torque to a fastener accomplishes a number of tasks. First of all correct torque will hold the parts together. This may seem like a trite statement but � think about it for a second. Engineers have designed
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
