Posted by ss55 on February 26, 2014 at 20:35:52 from (50.81.112.224):
In Reply to: Law advice needed. posted by jon f mn on February 26, 2014 at 11:54:42:
Do you know which requirements were not met, and can you correct it/them quickly?
You can talk to a lawyer to form a backup plan. Taking it to court could be expensive and will add several months to the process. I wouldn't count on much success with the DMV or to be able to force the clerk to cover your expenses. If you signed the application after you looked it over to confirm that everything was correct and you paid the lower fees for the lesser licence without questioning the price error it could be very tough to to prove the clerk intentionally did anything wrong, even if you both missed the same error.
As jm said, it may be simplest to just get it over with: study the manual, reapply and retake the tests again to be back on the road as soon as possible.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.