Posted by The tractor vet on February 24, 2014 at 11:21:38 from (75.19.125.103):
In Reply to: chain saws to buy posted by jbk on February 24, 2014 at 09:53:57:
Ya buy what you can afford and try and get the best bang for the buck. My first saw was a lambardi or something like that . I wanted a small saw i could carry in the truck while plowing snow as sometimes i had to deal with a downed tree . So i bought a 2.4 little Lighting with a 16 bar . Ya it was one heck of a saw and would cut with the big boys . It must have been a good one as it was stolen off my ft. closed in porch after the twister came thru that day. They got the saw the carrying case the gas and the bar and chain oil and the sharpner . To replace it i bought what i had money for and that was a Homealite 150 . Yea i know junk saw BUT it will cut and it can set for years and it will start on the seventh pull . Now earlier last spring i found a 455 Husky rancher stuffed in my evergreen tree , It's not mine and i saw no marks in the grass where it might have fallen off somebodys truck and bounced into the tree . So that must mean somebody had stolen it and was running with it at night and they must have seen headlights coming and ditched it on the run , figuring on coming back for it later . Well someone must own this saw and when he finds it missing he will call the cops. So i called the cops and had them come up and look , yea that is about all they did . So he takes the saw and stuffs it in the trunk and was going to take it back to the station . I asked if anybody had reported a saw missing ?? he told me no . OK well what if nobody claims it , he told me that if nobody claimed it after thirty days if i wanted it it was mine . Well it is in my truck now . Yep it runs great . price was wright on it .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
