Posted by Steve@Advance on February 24, 2014 at 09:19:12 from (108.245.66.82):
In Reply to: Massey Ferguson To-35 posted by James Madison Ag dep. on February 24, 2014 at 08:25:22:
First step is to procure an alternator. Most people go with a Delco with an internal regulator, fits mid 70's-80's GM products. You will also need the wire harness plug, available at the auto supply.
You will need to fabricate a lower mount. The reason you need the alternator first is to get the pulley alignment right. This is essential, take careful measurements, use straight edge, whatever it takes to get a good, solid, straight fit.
The wiring is simple, search "Delco alternator wiring" under images and you will get the diagram you need. You can reuse the "GEN" wire from the generator, just move it to the "BAT" terminal of the alternator, disconnect the other end from the regulator, then disconnect the "BAT" wire from the regulator, and splice the two together.
You can reuse the "field" wire from the generator, it will connect to the "1" term of the alternator, but remove the other end from the regulator and series wire a 15 ohm resistor or a 12v instrument lamp to the ign side of the ignition switch.
The #2 terminal will simply jump to the "BAT" terminal.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
