I would have preferred steep sides and little to no shallows. Reason is summer evaporation and predator birds, Blue Heron in particular. Problem with that wish is that spawning is usually done in shallow water if you have it. Problem with that is the Heron is there to fill up on your spawners.
Totally agree that you need clay to hold water. Sometimes it takes a few years for silt to fill in for clay if you don't have it to prevent leaks. Being a hole in the ground vs a bulge on the side of a hill really helps leakage.
Agree on depth and temp. You can tell that. Just take a swim and you can see for yourself where the thermocline exists.
I did implant white Crappie years ago and they just disappeared. Was surprised with the usual warnings.....caught them out of the creek in front of the house in the spring from the local lake.
If you want Catfish from fingerlings, don't stock bass; get some automatic floating CF bait feedders. If you want Bass, add perch and flat head minnows. Flat heads are said to reproduce 4x per season and are a good buy. Provide protected places for them to spawn. 1 cm hardware cloth works great to keep predators out.
I am a true believer in structure and without it the fry have little chance of survival. So an ample supply of limbs is a necessity. I like the willow in particular, the young ones like you get in the spring. Best bet is to grow a willow near the shore, then cut it till it falls into the water but leave 1/3 or so of the bark to keep it alive. Will be with you for many seasons.
Get your target practice on turtles, especially snappers. Will wipe you out along with the birds. Said to eat their weight daily. I had 12 this spring on my 2 acre pond. Took some work to get rid of them.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
