Posted by RodInNS on January 31, 2014 at 15:08:46 from (216.118.158.123):
In Reply to: CVT transmissions? posted by wile E on January 31, 2014 at 02:32:53:
I'm not really sure how the Steyr/CNH variable drive works... but the Fendt version is a hydro mechanical type of system that uses a type of hydro for the starting and light maneuvering type of stuff and then uses a variable drive system I think using a steel belt and sheaves or some similar idea. Regardless of how it's achieved, it is a very efficient, reliable system. Those tractors are pushing close to 400 hp today and I don't here about too many problems with them. Lots of guys are using them for hauling the large manure tanks because they're safer to work with then large 4WD tractors... From what I understand, the Deere IVT system is good but not quite as reliable as the Fendt. Massey uses the same basic componentry as Fendt with a different user interface... The big gain with the CVT transmission is that on lighter or varying loads it represents the opportunity to throttle back and still maintain appropriate ground AND PTO speeds so you can save a fairly substantial amount of fuel. On a dead pull such as heavy tillage.... no, it's probably not as effective or efficient as a power shift or gear drive.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
